induction pin brazing

Bin BrazingPin Brazing forms part of a technology developed in Sweden throughout the latter half of the 20th century by AGA. The purpose, for attaching current carrying cables to what were deemed “Sensitive Substrate Materials”, or in this case Railroad …

induction fusing the butt joint

Fusing the butt jointObjective: Fuse elastomer (TPE) tubes together in two ways, as a butt joint and as a overlap joint.Material: PeBax tubing 3/16” (4.76) OD, 1/8” (3.18 mm) ID and slightly largerStainless steel Teflon coated mandrel 1/8” (3.18 mm) dia…

induction heating brass mandrel die

Heating brass mandrel die Objective Water-cooled brass mandrel die, nylon LDPE catheter, “K” type thermocouple and temperature controller. Material materials, supplies involved in the application Temperature 400F (204C) Frequency 325kHz Equipment…

induction heating steel mandrel tip

Heating steel mandrel tip Objective Heat a water-cooled steel mandrel to 700F (371C) to form a high quality Teflon catheter tip.Material Teflon catheter tubing, mandrel assemblyTemperature 600-700F (315-371C)Frequency 376 kHzEquipment • Power of 10kW indu…

induction heating catheter tipping die

Heating Catheter Tipping Die Objective: To heat an aluminum catheter tipping die to above 2850F within 2 to 5 seconds for the forming of catheter material. Presently, heating is performed in 15 seconds with older induction equipment. The customer would lik…

induction heating fan blades for welding

Heating fan blades for welding Objective To uniformly heat jet engine turbine fan blades to 1800F (982.2C) within five minutes for a welding applicationMaterial Jet engine turbine fan blades with 2”(50.8mm) length tipTemperature 1800F (982.2C)Frequency 21…

induction soldering co-axial wire

Soldering Co-axial Wire Objective To solder center-conductor and shielding braid of wireassemblies to 500 (250) F(C).Material • Customer-supplied assemblies• Temperature indicating paint• Flux-cored solder wireTemperature 500 (250) F (C)Frequency 272 kH…

induction soldering wires onto connector

Soldering wires onto connector Objective Heat connector assemblies for solderingMaterial Device assemblyTin plated brass terminals Solder pasteTemperature 500F (260C) 5-7 secondsFrequency 360 kHzEquipment Power of 6 kW induction heating system equipped wit…

induction soldering satellite antennas

Soldering satellite antennas Objective Soldering steel onto GPS body for phone antennaMaterial Thin copper foil 0.3mm (0.01 in) thick Ceramic body 12mm (0.47 in.) long x 7mm (0.28 in.) wideTemperature 200 C (392 F)Frequency 371 kHzProcess Time 5 secondsEqu…

induction soldering brass

Soldering brass Objective To solder a brass end cap to a series of copper tubes Material Preassembled heat exchanger with copper tubes and 2 brass end caps 2.36” (60mm) OD, 0.08” to 0.12” (2 to 3mm) thick at both ends, liquid solder Temperature 30…