induction brazing brass trap block

Objective Block is heated to 1400F to braze trap tube to assemblyMaterial brass block and pre-formed tubesbraze pre-formsTemperature 1400 F (760C)Frequency 357 kHzEquipment Power of 20kW induction heating system including• Coil: custom-designed 2-turn spl…

induction brazing plumbing

Objective A copper-brass fluids union is brazed under constrained conditions (onboard a submarine), where access is limited and flame is not allowed. Material copper and brass plumbing components Temperature 750C (1380 F) Frequency 245 kHz Equipment Po…

induction brazing carbide

Objective Braze a carbide wear pad to steel for automated surgical forceps Material Steel assembly 1/2” (127 mm) long, 1/8 “ (3.175 mm)cross section Carbide wear pad Braze alloy Temperature 1350-1400 F (732- 760 C) Frequency 313 kHz Equipment Po…

induction brazing steel-carbide tool

Objective Provide a solution to this steel-carbide brazing applicationMaterial • Body 10mm; carbide tip 57 x 35 x 3 mm• Braze shim• Braze flux whiteTemperature 750C (1382F)Frequency 152 kHzEquipment Power of 10kW induction heating system, equipped with …

induction brazing steel to steel

Objective To braze O-ring Face (ORFS) sleeve or male connector to a steel tube. Material • Steel tube, 1 inch (2.54 cm) OD • O-ring Face Seal sleeve and a male connector fittings • Preform braze rings • White SureFlow flux • Steel support mandrel…

induction brazing carbide to steel

Objective Braze a carbide sleeve to a steel ‘T’ shank Material 2.0” (51mm) OD carbide sleeve, 1.0” (25.5mm) high braze joint, 1.5 ” (38 mm) steel ‘T’ , 50% silver braze ring Temperature 1292 F (700 C) Frequency 257 kHz Equipment • Power of 10 k…

induction brazing copper to copper

Objective To braze copper to copper bus bar assemblies together Material • 2 copper bus bars 6” (152.4mm) wide, 2’ (609.6mm)long, 2 copper bars 6”(152.4mm) wide, 18” (457.2)long & 3/8” (9.65mm) thick • braze shim preforms and white flux Tempe…

induction brazing stainless steel

Objective 1st Application: Braze hub assembly to needle holder 2nd Application: Braze Large tube to ring joint Material 1st Application: Steel hub assembly and needle 0.1” dia (2.5mm) 2nd Application: Steel tube 1” OD (25.4 mm) and ring Temperature 1…

induction brazing copper tube & pipe

Objective Braze brass fitting with o-ring to various diameters of copper tube. Material Various copper tubes ranging from 3/8” to 7/8” diameter and 2-3’ long, female brass fittings with o-ring, silver solder rings and glass beaker. Temperature 1300 F …

induction brazing carbide teeth to steel pipe

Objective Brazing carbide teeth to a steel jaw in less than 5 minutes Material Steel pipe jaw, 0.5” (12.7mm) dia, 1.25” (31.75mm) long, 0.25” (6.35mm) thick carbide teeth, black flux and silver copper braze shims Temperature 1292F (700C) Frequency 25…