Induction soldering solar panel
Views Send Enquiry
Objective Heat multiple joints on solar flex circuit strips to 500°F (260ºC) within ten seconds for a soldering application.
Material Flexible solar panel, Solder Plus Paste 63NC-A, 0.0625” (1.59mm) thick Teflon sheets
Temperature 500 °F(260ºC)
Frequency 278 kHz
Equipment •Power of 6 kW induction heating system equipped with a remote workhead with one 1.2 μF capacitor
• An induction heating coil designed and developed specifically for this application.
Process A specially-designed induction coil is used to provide even heat in the area where the wires on the solar circuits overlap.
A very light coat of solder paste is applied to the circuit connections and a small amount of pressure is applied to the
Teflon sheets to hold the circuits together. Power is applied for 10 seconds to flow the solder paste and bond the wires to the flex circuits
Results/Benefits Induction heating provides:
• Consistent and repeatable results
• Non-contact clean heating
• Flameless process
soldering solar panel
Related Content
induction brazing SS steel by handheld induction coil
induction melting silicon and steel
magnesium oxide acidic furnace for induction melting glass
induction preheating gas pipeline by full air cooled clamp induction coil and DSP induction heater
induction melting with Titanium alloy pot by customized induction coil
induction melting aluminium for casting wire wheel
induction heating steel plate by pancake induction coil
induction heating steel knife
Newest Comment
No Comment
Post Comment