induction sintering copper powder

Sintering copper powder Objective Sintering copper powder to a stainless steel shaft Material Steel shaft & shell assembly, approx 2” (50.8mm) diameter, 2” (50.8mm) tall, copper powder Temperature 1600 F (871 C) Frequency 54 kHz Equipment • …

induction soldering copper wires

Soldering copper wires Objective Soldering two copper wires to pre-installed turrets on a copper buss barMaterial Solder dipped copper/nickel buss bar, 2 tinned stranded copper wires, brazing stickTemperature 446 F (230 C)Frequency 230 kHzEquipment •Power…

induction soldering brass and copper

Soldering brass and copper Objective To heat brass and copper for soldering application on medical equipmentMaterial Brass ring, brass and copper pieces 5.11” (130mm) long, 4.3” (110mm) OD & 0.3” (7mm) at thickest point and solder ringsTemperature 3…

induction soldering copper

Soldering copper Objective Heat copper tab until the solder reflows. Material Copper tab 0.25 X 0.25 inch square about 0.05 inches thick. Lead free solder material (higher melting temperature than regular solder.) Temperature 500 F for 1.25 seconds …

induction brazing copper pivot

Objective Brazing a copper pivot assembly Material Two copper uprights 2” (5cm) wide x 4” (10.2cm) high, copper base 3” (7.6cm) x 2” (5cm) and .5” (1.3mm) thick with 2 channels for the uprights to the slide into, braze shims and black flux Temperatu…

induction brazing copper joints

Objective Brazing a joint between a copper lug and nickel plated copper pins on a pressurized heater connector. Material 1.5” (38.1mm) dia heater connector in a ceramic insulator with L shaped copper lugs and nickel plated copper pins, silver solder and …

induction brazing stainless steel hose to copper elbow

Objective Braze a stainless steel braided hose to copper elbows for a braided hose assembly. Material Stainless steel braided hose 3/8” (9.5mm) OD, copper elbow 1/4” (6.3mm) OD, braze preform rings and black flux Temperature 1400 F (760 C) Frequency 2…

induction brazing copper contacts

Objective Heat silver contacts and brass/copper bus for brazing application Material Silver contact .75 (19mm) diameter, brass and copper bus 2” x 1” (50.8 x 25.4mm), braze shims, white flux Temperature 1300 F (704 C) Frequency 320 kHz Equipment • P…

induction brazing copper to copper

Objective To braze copper to copper bus bar assemblies together Material • 2 copper bus bars 6” (152.4mm) wide, 2’ (609.6mm)long, 2 copper bars 6”(152.4mm) wide, 18” (457.2)long & 3/8” (9.65mm) thick • braze shim preforms and white flux Tempe…

induction brazing copper tube & pipe

Objective Braze brass fitting with o-ring to various diameters of copper tube. Material Various copper tubes ranging from 3/8” to 7/8” diameter and 2-3’ long, female brass fittings with o-ring, silver solder rings and glass beaker. Temperature 1300 F …