Induction Shrink Fit Cast Iron
Views Send Enquiry
Objective To use induction to prepare cast iron assemblies for shrink fit assembly
Material Customer supplied cast iron rocker arms of varying sizes
Temperature 450 ºF (232 °C)
Process Time 20 seconds
Frequency 48 kHz
Equipment Power of 25kW, 50-80 kHz solid state induction heating system, equipped with a remote heat station containing one 1.0μF capacitor
shrink fitting cast iron
An induction heating coil designed and developed specifically for this application.
Process A four-turn helical coil heats the ring at one end of the assembly. The coil is designed to concentrate the field towards the center of the assembly where the thermal mass is greatest.
Across the heated ring, the coil presents a lighter field. After heating, a pin is place within the ring and the assembly is water quenched.
The heat time varies from part to part but is less than 20 seconds.
Results/Benefits Induction heating satisfies the needs of this process for:
• rapid part heating
• flexibility for parts of differing geometries
• individual, series part heating, suitable for automation
• a clean source of heat
• even heat distribution
Related Content
induction brazing SS steel by handheld induction coil
induction melting silicon and steel
magnesium oxide acidic furnace for induction melting glass
induction preheating gas pipeline by full air cooled clamp induction coil and DSP induction heater
induction melting with Titanium alloy pot by customized induction coil
induction melting aluminium for casting wire wheel
induction heating steel plate by pancake induction coil
induction heating steel knife
Hot
induction heating inner surface
induction shrink fitting aluminium motor frame
induction shrink fitting coupling hub for oil pipes project by water cooled flexible induction coil
induction shrink fitting aluminum motors stators rotors
induction shrink fitting aluminum motors stators rotors
induction shrink fitting aluminum motors
induction shrink fitting aluminum motor frames to 350 celsius degree in 50 seconds by 60KW machine
induction shrink fitting
Newest Comment
No Comment
Post Comment