Induction Heating Inconnel Susceptor
Views Send Enquiry
Objective: Heat an Inconnel susceptor to 19500F in less than one (1) minute for heating jet engine fan blades. This approach is to be used, instead of directly heating the blade, since improved temperature uniformity will be achieved. Heating is to take place in an Argon atmosphere.
Material: Inconnel Susceptor measuring 1 3/8″ wide by 2″ long by 3/4″ thick
Temperature: 19500F
Application: Through laboratory testing, the Power of 10KW,10kW output solid state induction power supply along with a four turn elongated helical coil were used to achieve the following results:
# 19500F was reached in forty five (45) seconds.
# An even heating pattern was observed throughout the Inconnel block
Equipment: Power of 10KW,10kW output solid state induction power supply including one (1) remote heat station containing two (2) capacitors with a total value of 0.66 μF, and a unique four (4) turn elongated helical work coil.
Frequency: 215 kHz
heating Inconnel Susceptor
Related Content
induction brazing SS steel by handheld induction coil
induction melting silicon and steel
magnesium oxide acidic furnace for induction melting glass
induction preheating gas pipeline by full air cooled clamp induction coil and DSP induction heater
induction melting with Titanium alloy pot by customized induction coil
induction melting aluminium for casting wire wheel
induction heating steel plate by pancake induction coil
induction heating steel knife
Hot
induction painting after induction bending for pipelines
induction heating steel plate
induction remove copper from aluminium
induction heating stator frame
induction heating graphite mould
difference between induction heating inner surface and outside surface of steel ring
induction heating steel pot bottom
induction heating for heat preservation
Newest Comment
No Comment
Post Comment