Induction Heat the end of catalytic converter
Views Send Enquiry
Objective Heat the end of lorry catalytic converter exhaust system. The assembly must be held at target temperature for 200 hours, whilst the assembly is vibrated to test the weld strength.
Material Steel
Temperature 842 – 932 ºF (450-500 ºC)
Frequency 75 kHz
Equipment Power of 25 kW, induction heating system, equipped with a remote work head containing two 5 μF capacitors for a total of 10 μF and an induction heating coil designed and developed specifically for this application.
Process/Narrative A four-turn conical-shaped solenoid coil is used to heat the end of the exhaust system during the weld strength testing. It takes approximately 2 minutes to reach the target temperature between 842 – 932 ºF (450-500 ºC). This temperature is then held for 200 hours whilst the system is vibrated to simulate driving conditions. The weld is then inspected for cracks.
Results/Benefits Precision output of the power supply holds the desired temperature within a tight tolerance.
Heat the end of catalytic converter
Related Content
induction brazing SS steel by handheld induction coil
induction melting silicon and steel
magnesium oxide acidic furnace for induction melting glass
induction preheating gas pipeline by full air cooled clamp induction coil and DSP induction heater
induction melting with Titanium alloy pot by customized induction coil
induction melting aluminium for casting wire wheel
induction heating steel plate by pancake induction coil
induction heating steel knife
Hot
induction painting after induction bending for pipelines
induction heating steel plate
induction remove copper from aluminium
induction heating stator frame
induction heating graphite mould
difference between induction heating inner surface and outside surface of steel ring
induction heating steel pot bottom
induction heating for heat preservation
Newest Comment
Ate.
Ing. Omar Bonfiglio
Post Comment